TIE Intercepter- OK, where to start... I used the pod and wing connecters from the original POTF tie fighter and the wings from a POTF darth vaders TIE fighter. I started out by unscrewing the wing connecters from the vaders TIE wings and cutting the pegs off of the TIE fighters wing connecters.next, I used my dremel to cut out the whole middle section of the wing (seen in picture tie1.jpg). then i glued the wings to the connecters (seen in picture tie4.jpg). after that i took electricle tape and made the lines on which i would be cutting with my dremel to make the front of the wings pointed (seen in tie1.jpg). after i cut the wings to the right shape, i had to find something to make the border on it. I desided on using a plastic binder that you ofter use to hold reports etc, together (seen in tie1.jpg). I cut four of the to the right lenth and height and glued them on. debating on what to do next, i took apart the pod and taped up the black parts on thw wings. Then, I sprayed it all light grey
