Half-Finished C-3P0- Well, I made this figure on the seat of my pants.In other words, I had no idea how I was gonna do this. To make this figure I had to combine an Episode I 3P0 with a POTF2 3P0. This is not as easy as it sounds. Ok we'll start with the arms. For the left arm I used the top part and hand from the EpI version and the forearm from the POTF2 one. The right arm is the top part from the POTF2 version and the bottem half from the EpI one. The legs are done the same way, cut both the POTF2 and EpI figures at the joints (knees, elbows, etc.) and glue them together. The head is just the EpI head. I'm sure the other could have worked fine but I liked this one better. The pelvis is from the EpI version. Now the fun part - the torso!!! Ok, this worked out like crap for me. When I was splitting the torso in half to get the arms and head out, it cracked in half!!! And not where I wanted it to!!! Well, I sanded down the chest of the EPI version and the inside of the POTF2 one. Then I put the POTF2 chest piece over the top part of the EpI torso. I would have liked to make the chestpiece go all the way down to the circle on his belly, but I told you, IT SNAPPED OFF!!!!! So if you make this figure I suggest being careful with the torso.